L293D I.C. for Stepper Motor

This is a L293D I.C., a Push-Pull four channel Driver. I connect the chip to the proper wires on the Stepper Motor (600mA Max), and to the four outputs (that will be connected to the Motorola 68HC11).

2 Comments

  1. icpayd

    I connect the chip to the proper wires on the Stepper Motor (600mA Max), and to the four outputs (that will be connected to the Motorola 68HC11). Where did you get this information?

    Reply
    1. Daniel D. Wilcox (Post author)

      You can see the spec sheet for the L293D for more information. It says that 600mA is the maximum. The ic gets really hot if the current is increased passed that.

      Reply

Leave a Comment

Your email address will not be published. Required fields are marked *